You are on the updated version of the Eltex website. The site is currently under development, so some sections are unavailable for viewing. You can use the  previous version of the site .

Firmware update for switches MES23XX, MES33XX, MES2328I, MES35XX, MES5324

27 February 2025

Software Update

Firmware Version 4.0.24.1 
 

The firmware and detailed description of the product capabilities are available in the Downloads or on the product page. In case of any questions regarding the update, please contact the Technical Support Department of Eltex

Added

  • Added ability to disable command authorisation for individual line;
  • Added ability to specify source interface when working via TFTP;
  • Expanded number of map MAC rules that can be configured on an interface;
  • Added LACP force-up mode of operation;
  • Added ability to filter IP-interface and OSPF contexts in run-configuration;
  • Added output of extended TLV information in IS-IS database;
  • Added support for BGP temporary licences;
  • Added sending SNMP-trap when adding a unit to the stack;
  • Added support for reject-route in VRF;
  • Added SNTP support in VRF.

Fixed

  • The delay in re-authentication when receiving a Disconnect Request for a Dot1x session has been removed;
  • Fixed the premature transfer of ports to the forwarding state when rebuilding protocol trees (R)PVST,MST;
  • Fixed stack freeze with a large number of LACP, STP instances and NSF enabled;
  • Fixed the inclusion of RPVST instances in VLANs where this protocol is administratively disabled;
  • Fixed bug where device would not allow MAC-based VLAN configuration on new interfaces;
  • Fixed a critical error that occurs when authorizing commands using the TACACS+ protocol;
  • Fixed an error where after disabling the filtering of Martian addresses, the default route in the VRF acquires the failed to install status;
  • Fixed a critical error that occurs when an incorrect DHCP Discover packet arrives on the device;
  • Fixed an error causing an SSH connection to the device to fail;
  • Fixed an error in MSDP SA packets where the source prefix was incorrectly set;
  • Fixed a critical error that occurs when installing MSDP neighborhood;
  • Fixed an error with power supply to the additional CISCO phone panel;
  • Fixed issue where device reboots during MAC-based VLAN configuration;
  • Fixed standart ACL not being deleted;
  • Fixed issue with DDM mapping for FiberTrade FT-SFP+WDM-LR-20 and NPO Telecom JSC NGN-SFP transceivers;
  • Fixed spanning-tree portfast mode for RPVST/PVST.
0 products to compare
Show more
Compare